Description:
|
mscLpSdhTestCauseOfTermination OBJECT-TYPE
SYNTAX INTEGER {
testTimeExpired(0),
stoppedByOperator(1),
unknown(2),
neverStarted(3),
testRunning(4),
hardwareReconfigured(5),
loopCodeSyncFailed(6),
patternSyncFailed(7),
patternSyncLost(8) }
ACCESS read-only
STATUS mandatory
DESCRIPTION
"This attribute indicates either the status of the test or the cause of
the test's termination:
neverStarted indicates that the test has not yet been started.
testRunning indicates that the test has been started.
stoppedByOperator indicates that the operator issued a stop
command on a test that was running.
testTimeExpired indicates that the test ran for the time specified by
the test's duration.
loopCodeSyncFailed indicates that the local end failed to
synchronize to the loopCode pattern. The local end transmits the
loopCode pattern to cause the remote end to apply a loopback, after
which the local end should receive the loopCode pattern. The exact
pattern used to request loopCode depends on the test type. This
failure indicates a high rate of transmission errors, or that the
remote end has failed to apply the loopback.
patternSyncFailed indicates that the local end failed to synchronize
to the frmPatternType test pattern, that should have been looped
back at the remote end. This failure indicates a high rate of
transmission errors or the absence of a loopback.
patternSyncLost indicates that the local end gained and then lost
synchronization to the returned frmPatternType test pattern. This
failure indicates a sudden increase in transmission errors, frame
slippage, or the removal of an existing loopback.
unknown is set when a reason to terminate other than those listed
here is encountered.
Note: Only MSA cards support recognition of the failures
loopCodeSyncFailed, patternSyncFailed and patternSyncLost.
Other cards will not terminate the test under the conditions
described by these values."
DEFVAL { neverStarted }
|
|
