|
|
|
|
Description:
|
vsPlcMpathTable OBJECT-TYPE
SYNTAX SEQUENCE OF VsPlcMpathEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
"This attribute is optional and specifies the sequence of trunks to be
used as the route for the path, thus bypassing PORS' automatic
route selection. If the path fails the validation, no other path can be
selected1. This attribute should only be used in special cases since
the route selection algorithm is able to find and maintain the best
routes. A related path attribute, the pathType, determines if this
route will be used as a manual or forced path type.
As an example, the trunk component name for the third trunk on
node MoonBase is 'EM/MoonBase Trk/3'. Note that only the first
end of the trunk that the packet would encounter is provisioned.
These strings are case insensitive but the complete component name
must be input.
Note 1: the trunk designation must be a 3-letter form, e.g., 'trk'.
Note 2: only the outbound trunks component names are used to
provision the manualPath.
Note 3: It is recommended to have two independent routes specified
for a manual path by specifying a different manualPath
(non-symmetric) for each end. In this case, there is no way to select
which route will be used (first up wins) but if one path is torn down
due to a failure then the other manualPath may be used to reroute
the path."
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
iso(1)
vsPlcMpathEntry(1) 
