Description:
|
esafeErouterInitModeControl OBJECT-TYPE
SYNTAX INTEGER {ipDisabled(1), ipv4Only(2), ipv6Only(3), ipv4AndIpv6(4), honoreRouterInitMode(5)}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"This object provides control over the initialization
mode of the DOCSIS eRouter eSAFE element. Except
when set to honoreRouterInitMode(5), the value of this
object MUST override all Initialization Mode and
Operation Mode encodings encapsulated in the eCM
configuration file, e.g. TLV 202.1.
This object can only be set via an SNMP management
Station. This object cannot be included in the eCM
configuration file.
When this object is set to ipDisabled(1), the eRouter
is instructed to switch to IP Protocol Disabled Mode
and transparently bridge all traffic as described in
the eRouter Initialization section of the CableLabs
IPv4 and IPv6 eRouter Specification.
When this object is set to ipv4Only(2), the eRouter
is instructed to switch to IPv4 Protocol Enabled Mode.
When this object is set to ipv6Only(3), the eRouter
is instructed to switch to IPv6 Protocol Enabled Mode.
When this object is set to ipv4AndIpv6(4), the eRouter
is instructed to switch to Dual IP Protocol Enabled Mode.
When this object is set to honoreRouterInitMode(5), the
eRouter is instructed to honor the eRouter Initialization
Mode Encoding encapsulated in the eCM Config File under
TLV 202 as described in the Configuration of eRouter
Operational Parameters section of the CableLabs eRouter
Specification.
The value of this object MUST persist across cable modem
resets."
REFERENCE
"DOCSIS IPv4 and IPv6 eRouter Specification,
CM-SP-eRouter-I09-130404 Annex B.3."
DEFVAL {honoreRouterInitMode}
|
|
iso(1)
