|
|
|
|
Description:
|
esafeErouterAdminMode OBJECT-TYPE
SYNTAX INTEGER {disabled(1), ipv4Only(2), ipv6Only(3), ipv4AndIpv6(4), noTLV202dot1Present(5)}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This object provides visibility to the eRouter mode of
operation as specified by TLV 202.1.
If the value of this object is disabled(1), the
eRouter was configured via TLV 202.1 in the cable modem
configuration file to not initialize as described
in the eRouter Initialization section of the CableLabs
IPv4 and IPv6 eRouter Specification.
If the value of this object is ipv4Only(2), the
eRouter was configured via TLV 202.1 in the cable modem
configuration file to operate with an IPv4 network
address and with the IPv4 stack operational and to
operate without an IPv6 network address and to not
run an IPv6 protocol stack.
If the value of this object is ipv6Only(3), the
eRouter was configured via TLV 202.1 in the cable modem
configuration file to operate with an IPv6 network
address and with the IPv6 stack operational and to
operate without an IPv4 network address and to not
run an IPv4 protocol stack.
If the value of this object is ipv4AndIpv6(4), the
eRouter was configured via TLV 202.1 in the cable modem
configuration file to operate with an IPv4 network
address and an IPv6 network address and to run both
IPv4 and IPv6 protocol stacks.
If the value of the object is noTLV202dot1Present(5), the eRouter was not configured via TLV 202.1 in the cable modem configuration file."
REFERENCE
"DOCSIS IPv4 and IPv6 eRouter Specification,
CM-SP-eRouter-I02-070223."
|
|
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
iso(1)
