|
|
Description:
|
rsIpsecEndpointPairModule MODULE-IDENTITY
LAST-UPDATED "9909081200Z"
ORGANIZATION "WatchGuard Technologies, Inc."
CONTACT-INFO
" Ella Yu
WatchGuard Technologies, Inc.
1841 Zanker Road
San Jose, CA 95112
USA
408-519-4888
ella.yu@watchguard.com "
DESCRIPTION
"The MIB module describes generic Ipsec Endpoint Pair information
of RapidStream system. Mainly, the information
obtained from this MIB is used to constructed topological
view of IPSec security gateways that are connected by
IPSec tunnels.
An IPSec Endpoint Pair is a pair of security gateways that
are connected with 0 or more IPSec SA's in tunnel mode.
It contains information of aggregated information
of tunnel mode SA's between two security gateways.
An IPSec Endpoint Pair is identified by a pair of IP addresses.
Therefore, if an IPSec security gateway X has 2 external
IP addresses while IPsec secruity gateway Y has 3 external
IP addresses, there are potentially 6 IPsec Endpoint Pairs
between X and Y."
REVISION "200003211200Z"
DESCRIPTION
"Initial revision."
REVISION "200211011200Z"
DESCRIPTION
"Changed CONTACT-INFO."
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |