|
|
Description:
|
reachDSLSpectrumMgmtLoopMeasurementMethod OBJECT-TYPE
SYNTAX INTEGER {
none(1),
loopLength(2),
ewl(3),
quadMode(4)
}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This object has been deprecated. The corresponding
object in the new pdn_spectrumMgmt.mib should be used
instead.
This object indicates the measurement method used in
describing the Loop Length of a circuit. Following are the
details of each of the options:
none(1) - Indicates that the Spectral Compliance
is NOT dependant on any Loop Length
measurements or configurations.
loopLength(2) - The 'ConfLoopLength' object is used to
determine spectral compliance. The
'ConfEWL' & 'ConfQuadMode' objects are
not used in this mode.
ewl(3) - The 'ConfEWL' object is used to
configure the estimated loop length,
which is used to determine spectral
compliance. In this mode the
'ConfLoopLength' & 'ConfQuadMode'
objects are not used.
quadMode(4) - The 'ConfQuadMode' object is used to
determine spectral compliance. The
'ConfEWL' & 'ConfLoopLength' objects
are not used in this mode.
This object determines which of the three objects :
'ConfEWL', 'ConfLoopLength' or 'ConfQuadMode' is used
(if any) to enforce spectrally compliant maximum
'Tx Rates' and the maximum allowed 'Tx Power' on a given
circuit."
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |