|
|
Description:
|
serialConnectType OBJECT-TYPE
SYNTAX INTEGER
{ direct(1),
modem(2),
switch(3),
modem-switch(4)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"The type of outgoing connection to make. If this object
has the value direct(1), then a direct serial connection
is assumed. If this object has the value modem(2),
then serialConnectDialString will be used to make a modem
connection. If this object has the value switch(3),
then serialConnectSwitchConnectSeq will be used to establish
the connection over a serial data switch, and
serialConnectSwitchDisconnectSeq will be used to terminate
the connection. If this object has the value modem-switch(4),
then a modem connection will be made first followed by
the switch connection.
This object may not be modifed if the associated
serialConnectStatus object is equal to valid(1)."
DEFVAL { 1 }
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |