|
|
Description:
|
hpicfPoePowerRedundancy OBJECT-TYPE
SYNTAX INTEGER {none(1), nPlus1(2), full(3)}
MAX-ACCESS read-write
STATUS deprecated
DESCRIPTION
"This object is used to configure the
POE power redundancy mode.
A value of none(1) - means that all available power
can be allocated to powered devices.
A value of nPlus1(2) - means that one of the highest
power supplies is held in reserve and that in
the event of a single power supply failure, no
no powered devices will be shut down.
A value of full(3) - means that half of the available
power supplies are held in reserve.
The default value is none(1). In a stack, this
value pertains only to the commander switch."
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |