|
|
|
|
Description:
|
hpicfFfAction OBJECT-TYPE
SYNTAX HpicfFaultAction
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"This object is used to configure the action,
if any, to be taken if a fault of this type is
detected by the agent. Setting an instance of
this object to 'none' will clear any previous
state of the associated fault on all ports.
This object is used to enable or disable the
port disable feature for this fault type.
Setting this object to 'warnAndDisable' will
enable the port disable feature for this fault
type. This feature is intended to allow an agent
to disable ports that are being disruptive to the
rest of the network.
Note that not all agents will support setting
this object to 'warnAndDisable'. The agent
may choose not to disable a particular port for a
particular fault based on its knowledge of if/how
that fault disrupts the network."
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
