|
|
|
|
Description:
|
dot4Commands OBJECT-TYPE
SYNTAX INTEGER {
no-op(1), enterRing(2), exitRing(3), reset(4), initialize(5)}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Setting this object causes the station to change the state of the interface as indicated by the specified value. An initialize(5) command causes the interfaceto load its operational parameters from its initialization parameters; the value of dot4InitInRingDesired determines whether the station tries to enter the logical ring immediately.
Note that the 802.4 specification suggests a station remain Offline after a 'remote Network Management' reset(4),
until a 'local Network Management' initialize(5) is performed.
Setting this object to a value of no-op(1) has no effect. When read, this object always has the value no-op(1)."
|
|
Information:
|
Automatically extracted from IETF RFC 1230.
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
iso(1)
