|
|
|
|
Description:
|
pwUp NOTIFICATION-TYPE
OBJECTS { pwOperStatus, --start of range
pwOperStatus --end of range
}
STATUS current
DESCRIPTION
"This notification is generated when the pwOperStatus
object for one or more contiguous entries in the pwTable are
about to enter the up(1) state from some other state
except the notPresent(5) state and given that the pwDown
notification been issued for these entries. The included
values of pwOperStatus MUST both be set equal to this
new state (i.e., up(1)). The two instances of pwOperStatus
in this notification indicate the range of indexes that
are affected. Note that all the indexes of the two ends
of the range can be derived from the instance identifiers
of these two objects. For cases where a contiguous range
of cross-connects have transitioned into the up(1) state
at roughly the same time, the device SHOULD issue a single
notification for each range of contiguous indexes in an
effort to minimize the emission of a large number of
notifications. If a notification has to be issued for
just a single cross-connect entry, then the instance
identifier (and values) of the two pwOperStatus objects
MUST be identical."
|
|
Information:
|
Automatically extracted from IETF RFC 5601.
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
iso(1)
