|
|
|
|
Description:
|
mplsXCUp NOTIFICATION-TYPE
OBJECTS { mplsXCOperStatus, -- start of range
mplsXCOperStatus -- end of range
}
STATUS current
DESCRIPTION
"This notification is generated when the
mplsXCOperStatus object for one or more contiguous
entries in mplsXCTable are about to enter the up(1)
state from some other state. The included values of
mplsXCOperStatus MUST both be set equal to this
new state (i.e: up(1)). The two instances of
mplsXCOperStatus in this notification indicate the range
of indexes that are affected. Note that all the indexes
of the two ends of the range can be derived from the
instance identifiers of these two objects. For
cases where a contiguous range of cross-connects
have transitioned into the up(1) state at roughly
the same time, the device SHOULD issue a single
notification for each range of contiguous indexes in
an effort to minimize the emission of a large number
of notifications. If a notification has to be
issued for just a single cross-connect entry, then
the instance identifier (and values) of the two
mplsXCOperStatus objects MUST be the identical."
|
|
Information:
|
Automatically extracted from IETF RFC 3813.
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
iso(1)
