|
|
Description:
|
snmpFddiSMTConnectionPolicy OBJECT-TYPE
SYNTAX INTEGER (0..65535)
ACCESS read-write
STATUS mandatory
DESCRIPTION
"A value that indicates the connection policies
enforced at the station. A station sets the
corresponding policy for each of the connection
types that it rejects. The letter designations, X
and Y, in the 'rejectX-Y' names have the following
significance: X represents the PC-Type of the
local PORT and Y represents a PC-Neighbor in the
evaluation of Connection-Policy (PC-Type, PC-
Neighbor) that is done to determine the setting of
T-Val(3) in the PC-Signaling sequence (refer to
ANSI Section 9.6.3).
The value is a sum. This value initially takes
the value zero, then for each of the connection
policies currently enforced on the node, 2 raised
to a power is added to the sum. The powers are
according to the following table:
Policy Power
rejectA-A 0
rejectA-B 1
rejectA-S 2
rejectA-M 3
rejectB-A 4
rejectB-B 5
rejectB-S 6
rejectB-M 7
rejectS-A 8
rejectS-B 9
rejectS-S 10
rejectS-M 11
rejectM-A 12
rejectM-B 13
rejectM-S 14
rejectM-M 15
Implementors should note that the polarity of
these bits is different in different places in an
SMT system. Implementors should take appropriate
care."
REFERENCE
"ANSI { fddiSMT 27 }"
|
|
Information:
|
Automatically extracted from IETF RFC 1285.
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |