|
|
|
|
Description:
|
docsQosPktClassEnetProtocol OBJECT-TYPE
SYNTAX Integer32 (0..65535)
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"If docsQosEthPktClassProtocolType is none(0),
this object is ignored when considering whether
a packet matches the current rule.
If dosQosPktClassEnetProtocolType is ethertype(1),
this object gives the 16-bit value of the
EtherType that the packet must match in order to
match the rule.
If docsQosPktClassEnetProtocolType is dsap(2), the
lower 8 bits of this object's value must match the
DSAP byte of the packet in order to match the
rule.
If docsQosPktClassEnetProtocolType is mac(3), the
lower 8 bits of this object value represent a
lower bound (inclusive) of MAC management message
type codes matched, and the upper 8 bits of this
object value represent the upper bound (inclusive)
of matched MAC message type codes. Certain
message type codes are excluded from matching, as
specified in the reference.
If the Ethernet frame contains an 802.1P/Q Tag header
(i.e. EtherType 0x8100), this object applies to the
embedded EtherType field within the 802.1P/Q header.
If the referenced parameter is not present in the
INTERNET-DRAFT<draft-ietf-ipcdn-qos-mib-06.txt>November 2001
classifier, the value of this object is reported as 0."
REFERENCE
"SP-RFIv1.1-I07-010829, Appendix C.2.1.6.3"
|
|
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
