|
|
|
|
Description:
|
docsQosPktClassEnetProtocolType OBJECT-TYPE
SYNTAX INTEGER {none(0), ethertype(1), dsap(2), mac(3), all(4)}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This object indicates the format of the layer 3
protocol id in the Ethernet packet. A value of
none(0) means that the rule does not use the
layer 3 protocol type as a matching criteria.
A value of ethertype(1) means that the rule
applies only to frames which contains an
EtherType value. Ethertype values are contained
in packets using the Dec-Intel-Xerox (DIX)
encapsulation or the RFC1042 Sub-Network Access
Protocol (SNAP) encapsulation formats.
A value of dsap(2) means that the rule applies
only to frames using the IEEE802.3
encapsulation format with a Destination Service
Access Point (DSAP) other
than 0xAA (which is reserved for SNAP).
INTERNET-DRAFT<draft-ietf-ipcdn-qos-mib-06.txt>November 2001
A value of mac(3) means that the rule applies
only to MAC management messages for MAC management
messages.
A value of all(4) means that the rule matches
all Ethernet packets.
If the Ethernet frame contains an 802.1P/Q Tag
header (i.e. EtherType 0x8100), this object
applies to the embedded EtherType field within
the 802.1P/Q header.
If the referenced parameter is not present
in a classifier, this object reports the value of 0."
REFERENCE
"SP-RFIv1.1-I07-010829, Appendix C.2.1.6.3"
|
|
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |
iso(1)
